Bearings with conical inner holes can be mounted on the journal

The roller bearing is larger than the ball bearing capacity having the same shape size. The frictional resistance of the frictional bulk ball bearing is smaller than the roller bearing. If the radial load is large and the axial load is small, the bearing WeChat professional! The deep groove ball bearings can be used, and the outer ring has a bearing cylindrical roller bearing.

The bearing load size load size is usually a determinant of the size of the bearing size. . The most common arrangement of axial moving bearings is to install a "same-definition bearing" at one end of the shaft, and install a set of axial movable "swhanger bearing" at the other end to prevent heat through the axis Cold shrinkage causes a card death.

Under the radial load, the deep groove ball bearings and cylindrical roller bearings can achieve higher speeds, and when they are subjected to joint loads, the angular contact ball bearing should be selected. Various bearings can improve rigidity varying degrees by appropriately "pretension". At this time,Mechanical roller bearing manufacturers the inner ring and the mating of the outer ring and the outer sleeve can be used. .

The rotational speed of various thrust bearing is lower than the radial bearing. The frictional resistance is low, and less inner heating is suitable for high-speed operation. Bearings, angular contact ball bearings, tapered roller bearings, cylindrical roller bearings and thrust angles contact ball bearings.

Bearings with conical inner holes can be mounted on the journal, or with a tight sleeve or unloading sleeve on the cylindrical journal, it is convenient to install disassembly. Usually the ball bearing is suitable for light or medium loads, and the roller bearing is suitable for withstand heavy load

Bearings with conical inner holes can be mounted on the journal

ความคิดเห็น